Categories

1. Installation Instructions for the TT-13 Tiger Tail Fender Eliminator Plate
2. Remove Rear Seat/Hump and Grab Rail
3. Disconnect latch look cable from latch actualor
4. Remove Tail fiberglass assembly (be sure to unhook taillight wiring harness
5. Disconnect and Remove Battery
6. Dissconnect and remove ECU (and anything else you have hooked up on the tail section and
7. stock black plastic fender
8. Remove electrical harness from sub frame
9. Remove Rear Brake Reservoir (be careful not to drip any fluid onto anything...yuck!)
10. Remove the sub frame from the main frame
11. Remove stock plastic inner fender
12. Install TT-13 using the  same mount holes as stock inner fender
13. Reinstall sub fram to main frame
14. If installing a new Gel Battery, see picture

Be careful if Slamming a stock swingarm using 3rd adjusterhold.  It gets real tight in there! Install everything else left over. Hint, double stick-um Velcro works great.

If you cut off your square license plate light from your tail light, the fender extends out further and you can remount your license plate bracket under the tail light for illumination.
Thank you for purchasing a Tiget Tail Fender Eliminator.  Enjoy!