Dynatek Two Stage Retard/Advance Module

Description

The DYNATEK TSRAM Module is an accessory for use with the DYNA 4000 Pro Ignition System.  The Two Stage Retard/Advance Module (TSRAM) provides two independently adjustable ignition retard or advance stages that can be activated during a run.  You actually end up with three timing settings available: The static pickup and two stages of retard/advance.

This Module can be set up to 2 or 4 cylinder mode and can be set to progressively advance or progressively retard the pickup signal.  Each stage is adjustable from 2 to 20 degrees in 2-degree increments in a time frame of 0 to 4 seconds in .25-second increments.  Each stage is activated be applying a 12 volt signal to the trigger input corresponding to each stage.  The 12-volt trigger signal can be generated in many ways.  Several suggested ways of activating stages are listed below:

Use the 12-volt power to nitrous solenoids to activate retard when nitrous solenoids are energized.

1.      Use boost switch(es) to activate retard/advance when boost goes above a present level.

2.      Use a timer to activate retard/advance after a present delay.

3.      Use a DYNA Shift Counter to activate retard/advance in certain gears.

4.      Use an rpm activated switch (DYNA Shift Minder) to activate retard/advance above a preset rpm.

5.      Use a toggle switch to manually activate retard/advance.